ShareThis

Friday, November 20, 2015

DIFFUSING MACRO LITE FLASHES, OR RING FLASHES

I have never been a fan of ring flash / ring lite because the light is harsh and diffusion is not easy, but with Stephen's new and easy-to-DIY diffuser, getting good light is no longer an issue. You might want to check out another interesting method of diffusion for macro ring flash here as well.

All text and images are by Stephen Barlow (SteB1)

Macro Lite Concave diffuser

The aim of this diffuser design was to produce a low cost easy to use macro flash, with extremely good diffusion characteristics i.e. flash light that does not blow the highlights on shiny curved surfaces. I used the Yongnuo 14EX flashgun, as it is inexpensive, well built, and recycles very quickly. In addition the focusing lights can be operated by dabbing the shutter button. The LED focusing lights are very bright, and could be used to see at night in night time macro photography. This diffuser could be adapted to any Macro Lite type diffuser, or even a Ring Flash.

Macro Lite Concave diffuser

The design of the diffuser is based on my curved end of lens concave diffuser, which produces wrap-around light. In this design the whole diffuser face is approximately the same distance from the subject.

Macro Lite Concave diffuser

It's important to understand that this is a diffusion principle i.e. you can make different diffuser designs based on these principles, and I've been working on different designs.

You need these materials. A reflective hood. I used reflective mylar sheet with an embossed surface (used in hydroponic growing). Although you can use any reflective material, even just card with aluminium tape. I've used diffuser gel for the diffuser, although velum paper will do a similar job. The hood is attached to the flash head using self-adhesive Velcro tape. The centre piece, which helps to prevent a large black area in the flash reflection is best cut from the foam used for cheap camping mats (the photo shows expanded polystyrene). It's cut using a circle compass cutter. Push a hole right through foam with a needle, and then cut from either side, if the blade is to short to cut through the material.

Macro Lite Concave Diffuser Components

Macro Lite Concave Diffuser Components

The diffuser and hood are best the same length, and a 5cm length (the overhang) is a good all round size. It's easy to make and carry other lengths.

The diameter of the centre hole depends on the size of the front element of the lens and needs to be just big enough to prevent vignetting. With the camping mat foam the centre hole can cut it so it will take a Raynox close-up lens with a push fit.

The inner reflective tabs by the focusing light are to deflect the light in at close working distances. You can prevent light overspill by making the hood 1cm longer. Fold it over with a crease, and then cut to the crease every 1-1.5cm, so it will bend.

With this design you use the top tube as the main light. The bottom tube is either left off, or is used on the lowest power ratio setting for fill-in from below. Fill-in from below is useful with beetles that have a black underside. It also stops deep shadows under the subject.

You could build a diffuser like this for a true Ring Flash. However, you'd have to use several layers of diffuser gel over the bottom half of the tube to attenuate the light from below. Ideally you want the main light source to come from above as this creates modelling and brings out the detail in textured surfaces. This stops the lighting being too flat (light directly from the front with no shadows).

Sample images from this setup.

Harlequin Ladybird

A pair of Conopid Flies

Green Dock Beetles mating

Drone Fly (Hoverfly) on a Knapweed Flower

Ruby-tailed Wasp


   
As an Amazon Associate I earn from qualifying purchases.

No comments:

Post a Comment

LinkWithin

Related Posts with Thumbnails